Measurements

 Datasheet

1/23/2016

ByteSize

OK motors, use silver sparks instead

I recommend a 33:1 silver spark instead.(also sold on this website)

The 60:1 copals are too sluggish for the antweight robots in my region, and the shaft is too short to mount snap hubs.

2/16/2012

Koenigstiger

All the best !

Hallo,

I put two of these motors in my Trumpeter King-Tiger, scale 1/16 ! It runs very well, so that I ordered another few ! Great service with super motors !

Greetings from germany

The Koenigstiger

7/8/2011

ken

I used this motor for an RC project. It has plenty of torque for such a small motor and draws very little current. I did find with bigger wheels, this motor will stall under load. Using the recommended wheels, it would probably be ok.

12/11/2009

Michael

I've used these motors on a few different bots, always with great results. They provide a good speed and power mix. They work perfectly with the 3mm bore hubs and 1-1/2" lite flite foam wheels. Just keep in mind that they are not built for a very large bot and you should have good success.

11/7/2009

Ddub

never a problem

I've been using the same pair of 60:1 copals in my 3 lber for years and never had any problem. just 2 wheels drive in a spin bot.

5/19/2009

Dan Toborowski

These motors have served me well in various antweight robots but the plastic gears have often failed in battle. While these motors do offer good speed and torque with very low weight, the possibility of stripped gears makes these motors difficult to rely on. When it comes to combat robotics, I would highly suggest staying away from plastic gearboxes.

5/9/2009

Admin

Don't use on larger bots

This has been a great motor for smaller robots for many years, but it can be delicate if misused. It is NOT intended for larger bots or large diameter wheels. Best use is in an antweight (1 pound) robot with 2 inch or smaller wheels. When I hear people saying they stripped the gears in their 4.5 pound robot, I'm never that surprised- its just not enough of a motor for that large of a bot. For robots over 1 pound, you should be checking out the Beetle Series gearmotors instead.

5/9/2009

Jim

My antweight motors

I use this motor on all my 1 pound robots. Usually in a set of 2 (one per side) on 1-1/2 inch Lite Flite wheels, using 3mm hubs, a great setup in my opinion. If you could fit 4 of these into your bot (one for each wheel), you'd be in even better shape, as the motors will be able to share the load when you get into high torque pushing situations.

5/8/2009

Ron

Good speed but bad plastic gears

These motors were pretty lightweight and they ran at a good speed, but after a week or two, the plastic gears inside stripped, so these motors weren't functional anymore. It would probably be better or last longer for lighter robots. My robot was about 4.5 lbs, and it ran using 2 of these motors. It ran at a good speed, but the gears inside could've been of better quality.

5/7/2009

Seth

I've used these in probably all of my antweights at one point or another. They're a nice simple package that works well for beginners.