|
|
NPC-T64
One
of the most popular combat robot motors out there! This is the
motor that drives Nightmare, T-Minus, Diesector, Mechavore, and
many more. The T64 is ready to plug in and go. (motor is formerly
known as the 64038)
24V
(can be run at 36)
Reversible, Permanent Magnet
13 pounds
230rpm / 20:1 gear ratio
approx .7hp
|
|
|
NPC-T74
A
longer, more powerful version of the T64, it is a little faster
and a lot more torque than the T64. This motor is a great choice
for drive systems of a heavyweight or superheavyweight robot.
1.469" diameter stub shaft with four mounting holes.
24V
(can be run at 36)
Reversible, Permanent Magnet
14.4 pounds
245rpm / 20:1 gear ratio
|
|
|
NPC-2212
This
is a great little motor. The 2212 has a dual shaft design so
you can run it with two wheels for dual traction, or cut off
one side shaft for single wheel drive.
12V
(can not be run higher)
Reversible, Permanent Magnet
1/2" shaft diameter
5.1 pounds
285rpm / 21:1 gear ratio
|
|
|
NPC-41250
This
versatile 90 degree gearbox allows you to fit motors in places
you may otherwise be too constrained on space. This powerful motor
is a popular choice for middleweight robots. For 2 wheel drive
setups, just flip one motor around so
that the wheels line up.
12V
(can be run at 24V)
Reversible, Permanent Magnet
7.5 pounds
1/2" shaft diameter
93rpm (12V) 174rpm (24V) /48.5:1 gear ratio
|
|
|
NPC-B81 & B82
Both
B81 and B82 motors come standard with an electro-magnetic 24v
parking brake, which can easily be removed if that function is
not necessary. Built for continuous 24 volt 30 amp duty, they
can be run at 36 volts for 5 minutes, adding about 50% more speed
and torque. This motor comes in either left or right side shaft
drive configurations, and makes a great drivetrain for a large
robot. B81 is shown here. B82 is identical, but with shaft on
other side.
24V-36V
Reversible, Permanent Magnet
17 pounds trimmed
180 rpm / 18:1 gear ratio
11/16" shaft, 1/75" long |
|
4" wheel
shown
|
Build-your-own
Gearbox Kit
This
is a great solution for a small, low-profile, powerful gearmotor
kit. Complete 24v drive assembly kit. Kit includes: one motor,
one wheel, aluminum plates, bearings and gear set. Specially
designed for 60 to 120 pound robots.
Choose
from four wheels for the speed, power and profile that fits your
design. The 4:1 20p gears are made from A311 stress-proof steel.
The mounting plate & bearing block is 1/2" 6061 aluminum
and all holes are pre-drilled, all hardware and bearings is included.
The axle is 1/2" keyed steel. All parts included in one price.
See the wheels that are used here.
02446 |
Wheel |
MPH |
Ft/sec |
Total
Weight |
|
4" |
10 |
14 |
7.4
lbs |
5" |
12 |
17 |
7.7
lbs |
6" |
14 |
21 |
8.1
lbs |
8" |
19 |
28 |
8.6
lbs |
|
|
|
|