0-MANT-K Base-Loaded Micro Antenna <p align="left"><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">These micro antennas are fully assembled, tested, and come with gold-plated connectors.
No soldering is required since the receiver male connector pin is crimpable as
well. The overall length is about 7 inches, and weighs a mere 0.6 grams. Ready
to fly.</font></p>
<p align="left"><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">For use with original receiver antenna length of 36 to 40 inches.<br>
Mount antenna at least 1 inch away from any metal, carbon, wiring, batteries, etc.</font></p>
<ol>
<li><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">Check the range of your receiver with the factory antenna and record the results for comparison. </font></li>
<li><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">Cut your receiver antenna wire leaving 4 to 8 inches. Strip 0.125 inches of insulation from the end. </font></li>
<li><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">Solder (preferred) or crimp the connector pin to the antenna wire and apply a 0.5 inch piece of heat shrink tubing. </font></li>
<li><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">Glue or tape the antenna body to your model aircraft. Best range is achieved by running the antenna wire vertically. </font></li>
<li><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">Always range check your aircraft before flying. Check with and without the motor running.</font></li>
</ol>
<p align="left"><font color="00ff66" size="2" face="Arial, Helvetica, sans-serif">Note: The overall range with this micro antenna is reduced compared to the factory antenna, and in most cases it is insignificant. Designed for the 35, 72, & 75 MHZ bands. Weight is 0.6 grams with connectors.</font></p>