This product has been discontinued. Please see this similar product instead.When performance matters in your high-current applications look no further than the E-flite 60-Amp Pro Switch Mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated Switch-Mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 60 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic endcaps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range, and more, the E-flite 60-Amp Pro Switch Mode ESC is truly a 'pro series' electronic speed control.
Features
Up to 60-amp continuous current with proper air flow, 75-amp peak
5-volt Switch-Mode BEC circuit capable of 2.5-amp continuous current on any recommended input voltage
Drives up to 7 analog or 6 digital standard-sized servos, with the BEC on any recommended input voltage
3-6S Li-Po, 9- to 18-cell Ni-Cd/Ni-MH input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V), or 70% of battery starting voltage
Programmable soft start for helis and airplanes
Auto motor shut down if signal is lost or there is interference
Programmable timing--5 user-selectable ranges for use with a larger variety of brushless motors
Programmable throttle input range (1.1-1.9 ms or 1.2-1.8 ms)
Utilizes new smaller MOSFETs technology to minimize weight
Radio System Power On/Off Switch
Optional RS232 Serial Link available for programming
Pre-wired connectors--E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads
Specs
Brake: Yes - Programmable
Continuous Maximum Current: 60A with reasonable cooling
Input Voltage: 10.8V - 22.2V
Input Connector Types: 13AWG with E-flite EC3 connector
Output Connector Types: 13AWG with 3.5mm Female Gold Bullet Connectors
Momentary Peak Current: 75A (15 sec)
Dimensions: 76 x 33 x 13 mm (3 x 1.3 x .5 in)
Weight: 66 g (2.3 oz)
Wire Gauge: 13AWG
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd