The Pixie-7P provides modelers flexibility
through the use of user-programmed features. Using an on-board LED and your
throttle stick, you decide the cut-off voltage, motor cut-off, and throttle
range options on this ESC!
The Pixie-7P can be used with Speed-280 and smaller motors where current draw
will be 7 amps or less. It comes with custom-made 24 gauge silicone wire for
battery and motor leads.
The Pixie-7P can be set up for lower cut-off voltages for 3 or 4 cell NiCad
packs, higher cut-offs for lithium cells or 10-16 cell NiCad packs, or no cut-off
for micro helis. The unit comes pre-programmed for standard 5-10 cell aircraft
operation (4.7V cut-off).
Features
-Battery Eliminator Circuit (BEC): eliminates receiver battery
-Safe "Power On"
-Low torque "Soft Start": protects gear boxes and belt drives from
shock
-Simple setup: no complicated switches or wiring
-Tough surface mount construction
-Smooth reverse exponential throttle
-Audible Arming Signal
-Self-calibrating endpoints: maximizes usable stick travel
-Auto Motor cut-off with reset
-Auto shut-down when signal is lost
-Microprocessor Controlled
Cells
with BEC |
|
Cells
without BEC |
3-18 |
Continuous |
7A |
Switching
Rate |
2800
hz |
Resistance |
0.007ohms |
Brake |
No |
Reversible |
No |
Low Voltage Cut-off |
Programmable |
Size |
0.28
x 0.58 in. |
Weight (with wires) |
0.11oz |
Connector
Type |
Universal |